Specifications
Noble Model-200
|
Output power in watts: FTC: 20 Hz-20 kHz @ 0.1% THD, both channels driven |
8Ω per channel |
185 watts |
|||||
|
4Ω per channel |
280 watts |
||||||
|
Output power in watts: EIA: 1kHz @ 0.1% THD, both channels driven |
8Ω per channel |
200 watts |
|||||
|
4Ω per channel |
300 watts |
||||||
|
1 kHz @ 1% THD, typical both channels driven |
2Ω per channel |
430 watts |
|||||
|
Output power in watts: Bridge Mono (Through special factory mod only) |
8Ω, 20 Hz-20 kHz, 0.1% THD |
530 watts |
|||||
|
8Ω, 1kHz, 0.1% THD |
600 watts |
||||||
|
4Ω, 1 kHz, 1% THD, typical |
830 watts |
||||||
|
Dynamic headroom |
2 dB @ 4 Ω |
||||||
|
Distortion |
SMPTE-IM |
<0.01% |
|||||
|
Frequency response |
At 10 dB below rated output power |
20 Hz-20 kHz, +0/-1 dB –3 dB points: 5Hz and 50 kHz |
|||||
|
Damping factor |
> 300 @ 8Ω |
||||||
|
Noise |
Unweighted 20 Hz to 20 kHz, below rated output 100 dB |
||||||
|
Voltage gain |
31.6x (30 dB) |
||||||
|
Input sensitivity, V RMS |
Full rated power @ 8Ω |
1.15v (+3.4 dBu) |
|||||
|
Input Impedance |
10 KΩ unbalanced 20 KΩ balanced |
||||||
|
Controls |
Front: AC
switch Rear: 10 position DIP switch |
||||||
|
Indicators |
Power: Green LED |
||||||
|
Connectors |
Input: Active
balanced; XLR , Gold/Teflon RCA Jacks, Binding posts |
||||||
|
Cooling |
Convection only if heat sink is below 35 C (95 F).
Quiet continuously variable speed fan, front-to-back air flow if heat sink is
below 35 C |
||||||
|
Amplifier protection |
Full short circuit, open circuit, thermal, ultrasonic,
and RF protection Stable into reactive or mismatched loads |
||||||
|
Load protection |
Turn-on/turn-off muting. AC coupling, triac
crowbar (on each channel) |
||||||
|
Output circuit type |
AB |
||||||
|
Dimensions |
19.5” (49.5 cm) wide, 6.75” (17.1 cm) tall (feet to
top of Heat Sink), 16.18” (41 cm) deep (rack mounting to rear support ears) |
||||||
|
Weight |
Shipping: 47 lb. (21.4 kg) |
Net: 41 lb. (18.6 kg) |
|||||
|
Power requirements |
Available for 120 or 220-240 VAC, 50/60 Hz |
||||||
|
Power consumption @ 120 VAC both channel driven (230VAC -Multiply currents by 0.5) |
Typical |
Idle 0.5A |
8Ω 3A |
4Ω 4.5A |
2Ω 6.5A |
||
|
Full |
|
8Ω 4.1A |
4Ω 6.6A |
2Ω 9.5A |
|||
|
Max |
|
8Ω 7.4A |
4Ω 11.5A |
2Ω 17A |
|||